10
STANDARD OR ANGLE MOUNTING INSTRUCTIONS
4. Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify the
wiring. If you decide to cut back the lead wires, it is
suggested you do so in the following manner:
• Take the lead wires and make sure you have pulled
them all the way through the top of the downrod.
• Measure 8 inches of lead wire, then cut the excess
wire off with wire cutters (not included).
5. If you decided to cut back the lead wire in Step 4, strip
1/2 in. of insulation from the end of the white wire.
Twist the stripped ends of each strand of wire within
the insulation with pliers (not included). Repeat the
step for black and blue wires.
Note:
If you did not cut back the lead wires in Step 4,
Step 5 is not necessary and you may proceed to Step
6 instead.
6. Install the ball end of the downrod (A) into the opening
of the mounting bracket (D). Align the slot in the ball
with the tab in the mounting bracket (D).
Important:
The downrod should not rotate if it is
installed properly.
DANGER:
Failure to align a slot in the ball with
the tab may cause the fan to wobble or fall, which
could result in serious injury or death.
6
A
D
Tab
Slot
4
8 in.
5
