U
U
X
X
V
V
Step 11:
Step 12:
Page 14 of 18
2 pcs
2 pcs
U
2 pcs
M8 x 25mm
Bolt set
Counter-sunk screw
set (M6x12mm)
Counter-sunk screw
set (M4x12mm)
1 pc
V
1 pc
Allen key (2.5mm)
Allen key (4mm)
If
the
TV is supplied with Vesa bolts
and spacers
, please use those in
preference
to
those provided
ii.
iii.
Check the hardware supplied with the
television and if Vesa bolts and spacers
are supplied please use these to fit the TV
.
i.
iv.
To adjust the two TV supports (W),
stand the TV in position and loosely
secure it to the bracket using the
hardware supplied. Each slider should
be set to just touch the front bezel. To
make sliding each support easier, lift
the TV slightly, above the support
being adjusted.
Once supports are set, lightly push
down In the top centre of the TV
and tighten the two Vesa bolts
100%, these should be in the centre
of the long holes as shown.
If hardware is not
supplied with the
TV, choose suitable
fittings from the TV
Kit
X
2 pcs
Spacer for fitting to rear of
the TV. If no spacers are
supplied with the TV
itself,
please use
these
two marked (X)
making sure the
bolt length is correct.
Fit
them in the
position shown in Step 11
part ii.
It is important to fit them to allow more
clearance for the TV hinge system.
When spacers are provided it is
very important that these are fitted
in the correct place, fit between TV
& TV bracket as in this sketch.
These are needed to keep the TV
screen vertical.
TV BRACKET
