EN
(70)
Haojue TZ150S 99011H36640H000 V01 ES+EN 2015-1-17
B
CAUTION
Holding the dimmer switch between “
9
” and “
'
”
position will turn on both “
9
” and “
'
” headlight
beams. This operation can damage the motorcycle.
Use the dimmer switch only at “
9
” and “
'
”
position.
Do not stick tape on the headlight or
place objects in front of the headlight.
OVERTAKING SWITCH
2
:
Press the switch to flash the headlight.
CLUTCH LEVER
3
The clutch lever is used for disengaging the drive to the
rear wheel when starting the engine or shifting gears.
Grasping the lever disengages the clutch.
NOTE: The clutch lever provided with a clutch switch.
Electric start can be realized smoothly when the clutch
lever is firmly grasped.
HORN BUTTON
4
,
Pressing this button will trigger the horn.
TURNING SIGNAL SWITCH
5
= 8
Moving the switch to the “
=
” position will engage the
left turn signals. Moving the switch to the “
8
” position
will engage the right turn signals. The indicator on the
dashboard will also flash. To cancel turn signal operation,
push the switch inward.
B
WARNING
Failure to use and failure to turn off the turn signals
can be hazardous Other drivers may misjudge your
course and this may result in an accident. Always
use the turn signals when you intend to change
lanes or make a turn. Be sure to turn off the turn
signals after completing the turn or lane change.
CHOKE LEVER
6
(A)
(B)
(C)
To make starting convenient, the motorcycle is provided
with a choke. During a cold engine start, pull the choke
lever to the position (A) and open throttle grip slightly to
start the engine. After the engine is started, pull back
the choke lever by half to position (B) and open throttle
grip slightly to make the engine continually preheat until it
reaches the required temperature. Finally, pull the choke
lever back to its original position (C). During a hot engine
start, put the choke lever in position (C).
(70)
Haojue TZ150S 99011H36640H000 V01 ES+EN 2015-1-17
11
https://www.motomanuals.net/
