12
-
17
Hanskamp AgroTech B.V. (the Netherlands)
www.hanskamp.nl/en
FeedStation
EN
42000
10. Position the entire FeedStation in the correct place and attach it to the floor using
foundation anchors or cotter bolts. Use M12 mounting components (Fig. 12). If the feet
do not come out properly, the entire frame can be moved forward or backward. Allow
for the fact that everything will have to be positioned fully level again afterwards.
Please note! Mounting components for fixing the FeedStation into place
are not supplied with the standard pack.
11. Attach the relevant electronics to the feed station. Connect the
PipeFeeders. Holes have already been made in the feed trough
’
s
sender/receiver plate for different brands/types of
senders/receivers/controllers.
12. The cabling can be fitted along the underside of the trough using tie
-
wraps. The two
protruding tubes in the connecting gate can be used as cable conduits to feed the ca-
bling upwards.
Connecting FeedStations
It is easy to connect FeedStations alongside each other. All that is needed is one inter-
vening fence. This saves on a lot of parts.
The FeedStation can even be connected to the
L
’
port closing gate.
The modular con-
struction means that even mirror image setups or three FeedStations alongside each
other are possible.
12
Please note! Make sure that the PipeFeeders are aligned correctly so that they do not spill if a cow knocks against them.
(See manual 001
-
847
-
000, PipeFeeder.)
Please note! Always use a cable conduit or protective pipe to protect the cables and wiring from external mechanical
impacts.
Please note! Always make sure the cabling is hidden away, out of reach of the cow.
Please note! Make sure the electronics and feed station are earthed.
Please note! Calibrate the PipeFeeder feed dosator before use. Repeat this once a month or when changing feed type.
Please note! Do not climb onto the feed station because of the danger of falling.
15
13
14