Page GB-27
Installation, connection and initial commissioning
To adjust the door
– so that it is easier to open, turn the screws
in an anti-clockwise direction.
– so that it is more difficult to access, turn the
screws in a clockwise direction.
Degree of water hardness
Determine water hardness
In order to determine the water hardness in
your place of residence, you can
– look on the website of your water provider.
– telephone your water supplier.
– purchase suitable test strips at the phar-
macy.
Water hardness in
your household in
°dH
Water hardness in
the dishwasher
0-5
H1
6-11
H2
12-17
H3
18-22
H4
23-34
H5
35-55
H6
1. Determine the relevant setting from the
table above.
2. Open the dishwasher door.
Adjusting the water hardness
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
(1)
(2)
1. Open the door.
2. Switch on the dishwasher using the (1)
button.
3. Press and hold the P (2) button for as
long as required until the display shows
only the current water hardness:
H1
to
H6
.
4. Press and hold the P (2) button as often
as required until the display shows the
desired setting.
5. Switch the dishwasher off using the but-
ton (1).
The hardness level setting is saved.
Test run
It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the device
functions perfectly.
If no water escapes during the test run and if
there are no unusual noises, the appliance is
ready to use.
Carry out this test run when the dishwasher
is empty and without any dishwasher deter-
gent.
See chapter „Dishwasher operation“ on
page GB-17 for the procedure.
