Page EN-26
Installation
Connection to the power
supply – notes for the installer
WARNING
Risk of electric shock!
Faulty electrical installation or excessive
mains voltage may result in an electric
shock.
■
Connection to the mains supply
may
only be made by an authorised elec-
trician
approved by the local ener-
gy supply company, e.g. our service
center (see page EN-29). Only then will
you benefi t from our warranty and a
suffi cient level of safety.
■
Since all poles of the appliance can-
not be disconnected from the mains
via an accessible disconnecting de-
vice, an all-pole disconnecting device
in accordance with overvoltage cat-
egory III must be connected within
the house installation with at least 3
mm contact clearance.
Connection conditions
– The hob is designed for alternating current
220 – 240 V~ / 380 – 415 V 3N~ / 50 Hz.
– A separate power supply is required.
– The hob may be connected only with the
pre-installed network connection of type
H07RN-F with a conductor cross-section
of at least 4 x 2.5 mm
2
.
– When connecting the appliance, VDE
specifications and the “Technical connec-
tion requirements” must be observed.
Contact protection must be guaranteed.
Connecting the mains cable
1. Before accessing the terminals, switch
off all supply circuits and secure them
against being switched on again.
2. Make sure that the connection cables are
voltage-free on all poles.
3. Make sure that effective earthing is pos-
sible before connecting to the appropriate
terminal.
2 2 0 – 2 4 0 V ~
/
380 – 415 V 3N~ 50 Hz
Black = L1
Brown = L2
Blue = N Green/Yellow
= PE
L1 L2
N
230 V
230 V
4. Connect the mains cable to the cooker
outlet as shown in the wiring diagram.
5. Lay out the power cord in such a way that
it does not touch the housing of the hob,
as it can get very hot during operation.
Summary of Contents for MC-IF7127B2C-A
Page 34: ......
