Cleaning before use
To remove the odour which is present in all
new appliances, wipe the interior with dilut-
ed vinegar prior to first use. Then wipe it out
with clean water and dry all of the parts off
afterwards.
Commissioning the appliance
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■
Do not operate or continue to oper-
ate the appliance if it
–
shows visible signs of damage, e.g.
the power cord is defective,
–
starts smoking or there is a smell of
burning,
–
makes unfamiliar noises.
Should this occur, remove the mains
plug or unscrew/isolate the fuse and
contact our service department (see
“Service” on page EN-32).
■
If the mains plug is no longer acces-
sible after connecting it, an all-pole
disconnecting device complying with
overvoltage category III must be con-
nected into the house wiring with a
contact gap of at least 3 mm; consult
a qualifi ed professional if necessary
(see “Service” on page EN-32).
■
Do not kink or pinch the mains cord
or lay it over sharp edges. This can re-
sult in a break in the cable.
Fire hazard!
Improper handling of the appliance can
lead to fi re and damage to property.
■
Do not connect to a timer or a sepa-
rate remote-controlled system for dis-
tance monitoring and control.
■
Do not locate multiple portable sock-
et outlets or portable power supplies
at the rear of the appliance.
CAUTION
Fire hazard!
Improper handling of the appliance can
lead to fi re and damage to property.
■
Connect the appliance only to a
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
■
Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Insert the mains plug into an easily ac-
cessible and properly installed socket
(220–240 V~/50 Hz).
When opening and closing the upper door,
the interior lighting (1) is automatically
switched on and off.
You will find all important information
about operation from page EN-11.
Getting started
Page EN-24
