Page EN-36
Troubleshooting table
Problems with operation
Problem
Possible cause
Solution
The dishwasher cannot
be switched on.
The mains plug has not
been inserted into a socket.
Insert the mains plug into the
socket.
There is no voltage being
supplied through the socket.
Check the fuse. Check the socket
by connecting another device.
The selected
dishwashing
programme will not
start or it stops.
The dishwasher’s door is not
closed properly.
Close the dishwasher door.
The water tap is not properly
on.
Turn the water tap on completely.
The inlet hose is defective.
Contact our Service Centre
(see page EN-39).
There is a risk of overflow-
ing. The electrical water stop
system has been activated.
The display (12) is
illuminated although
dishwasher salt has
been added.
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the
end of a spoon or similar.
The water is not
running or it is running
only very slowly.
There is a kink in the inlet
hose.
Arrange the inlet hose properly so
that it is not kinked (please see
page EN-29).
The water tap is not properly
on.
Turn the water tap on completely.
The water is not
running off or only very
slowly.
The filters are blocked.
Clean the filters (see „Checking
and cleaning the filters“ on page
EN-26).
The outlet hose is kinked,
has been extended or is
hanging too high up/too low.
Lay out the outlet hose in the prop-
er manner (see page EN-28).
The dishwasher is not
watertight.
The door seal is defective.
Have the door seal replaced
(see „Service“ on page EN-39).
The outlet hose or the inlet
hose is defective.
Have the defective hose replaced
(see „Service“ on page EN-39).
The dishwasher can be
switched on/off, but not
cannot be operated.
The dishwasher can only be
operated when the door is
closed.
Close the door.
