Operation
Page EN-11
Operation
The LED display
Reset
Filter Change reminder
Filter Change reminder
Air quality
1
2
(2)
(3)
Filter change indicator
If one of the Filter Change Reminder LEDs (2)
lights up, the corresponding filter must be re-
placed.
Filter 1 = Activated Carbon filter
Filter 2 = H13 filter
The process is described in chapter “Chang-
ing the filters” on page EN-14.
Air quality indicator
Your appliance measures the levels of fine
dust particles smaller than 2.5 micrometres
in diameter (PM 2.5) in the indoor air. These
and larger fine dust particles are filtered out
of the air by the appliance.
• The air quality is shown with the LED “Air
quality” (3). Its colour changes from blue
to light blue and pink to red depending
on the air pollution level. Blue stands for
very good air quality, red for very poor air
quality.
The control panel
Power
Mode
Fan speed
Timer
Reset
Filter Change
Filter Change
Turbo
Auto
Sleep
Low
Mid
High
1H
4H
8H
(9)
(10)
(11)
(12) (13)
(9) Power
:
• This button switches the appliance on and
off. After the appliance is switched on, a
beep will sound and the appliance starts
in automatic mode.
• To switch off the appliance, press the
Power button again.
(10) Mode
:
• Press this button repeatedly to change
the setting.
• Turbo: The filter effect is strongest in this
mode. This setting is recommended for
very bad air, e.g. in smoking areas. The
fan runs at maximum speed here so it is
quite loud.
• Auto: This setting automatically adjusts
the filter effect according to the degree of
air pollution. When the room air is good,
the appliance is barely audible; when the
room air is bad, the fan runs faster and
the volume increases.
The appliance is also equipped with a light
sensor that automatically puts the appli-
ance into sleep mode and switches off all
LEDs when it gets dark. When there is light,
the appliance returns to normal operation.
• Sleep: Select this setting if you want the
appliance to operate as quietly as possi-
ble, e.g. at night.
(11) Fan Speed:
• Repeatedly pressing this button allows
you to set three additional fan speeds:
low, mid and high.
