Page EN-26
Installation, connection and initial commissioning
(f)
4. Insert the two mounting brackets (f) into
the front slots on the top of the dish-
washer so that you can screw the dish-
washer to the worktop subsequently.
(d)
5. Remove the protective films from the
side end profiles (d).
6. Affix the end profiles to the left and right
edges of the dishwasher. This will pre-
vent a crack being visible between the
dishwasher and the adjacent kitchen
cupboards.
7. Push the dishwasher into the recess.
UP
DOWN
(18)
8. To position the dishwasher so that it is
level, the two front adjustable feet (18)
and the back adjustable foot of the appli-
ance can be adjusted by up to 50 mm.
– The front feet are equipped with slots.
Insert a screwdriver into one of the slots
and turn the feet to the height required.
– You can adjust the height of the rear
adjustable foot with the centre adjusting
screw. Use a Phillips-tip screwdriver for
this.
9. Check the alignment with a spirit level.
10. Make sure the top edge of the dishwash-
er is level with the bottom edge of the
worktop to prevent it from tipping forward
when you open the door.
(f)
(i)
(e) (k)
11. Screw the dishwasher to the kitchen
unit.
