Page EN-29
Set up and connection
Carrying out a test run
Before getting started
• Read the “Safety” chapter from page EN-4,
in particular the safety notices.
• Remove the transport safety devices
and prepare the appliance as described
in chapter “Set up and connection” on
page EN-25.
• Properly attach the water inlet hose and
the water outlet hose (17).
Possible residual water or drops in the
appliance are merely a sign that it was
tested for functionality during production.
The appliance requires an initial wash cycle
without laundry, but with detergent. The aim
of this is to rinse out possible residues from
production.
1. Check whether the water inlet hose (32)
and water outlet hose (17) are securely
connected.
2. Open the valve completely.
3. Make sure that the drum is empty.
4. Push the appliance door (13) tightly
closed.
200
150
100
(19)
(1)
5. If the partition (19) is located in the left
chamber II of the dispensing drawer (1),
take it out. Keep it in a safe place: It is re-
quired when using liquid detergent.
6. Dispense a maximum of 25 ml of compact
detergent into left chamber II.
Aus
Buntwäsche
Wolle
Spülen
Allergie
Hand-/
Feinwäsche
Mix
Kurz 60'
Extrakurz 15'
Eco 40-60
Baumwolle
Baumwolle
Baumwolle
20°C
Jeans/
Dunkle Kleidung
Schleudern/Abpumpen
//
Sport /
Pflegeleicht
Anzeige
Funktionen
Schleudern Startzeit-
vorwahl Vorwäsche Knitterschutz
Start/
Pause
Temp.
(2)
(3)
(9)
e
e
7. Set the cycle selector (2) to the “Cotton”
cycle.
The cycle time is shown in the display (3).
The “Start/Pause” indicator (10) will
flash.
8. Press the “Start/Pause” button (9).
The cycle starts; the “Start/Pause” in-
dicator (10) lights up permanently. The
remaining cycle time is shown in the dis-
play (3).
After the cycle has finished, “End” will ap-
pear in the display (3).
9. Turn the cycle selector (2) to “Off”, take
the mains plug out of the socket, and
close the valve.
Start-up is now finished.
Summary of Contents for 11976452
Page 74: ......
