HANSCRAFT TP 700, User Manual

Page: 14 / 40

14
Control panel
Fine tune your spa with a wide variety of settings
Navigate to Settings to view and/or control your spa. (View chapter 5.2, on page 10,
“Navigate the Settings menu”). This is an example of a Settings list . Your Settings list
may vary.
HEAT
Make sure your spa is heated and ready to enjoy with Heat Settings (View chapter 5.8.1).
TIME
Set the Time to insure scheduled features have proper timing (View chapter 5.7).
REMINDERS
Reminders are helpful spa maintenance messages that display periodically.
LOCKS
Lock the Panel and/or Settings (View chapter 5.10).
FILTER
Keep your spa water clean and ready to enjoy by setting Filter Cycles (View chapter 5.6).
HOLD
Hold is used to disable the pumps during service functions like cleaning or replacing
the filter. Hold Mode will typically last for 1 hour unless the mode is exited manually.
You can see how much longer Hold will last at the bottom of the screen (for example,
“Holding for 0:58”). If you exit this screen, Hold Mode ends. If spa service will require
more than an hour, it may be best to simply shut down power to the spa.
Drain mode (optional)
Some spas have a special feature that allows Pump 1 to be employed when draining the
water. When available, this feature is a component of Hold.
CLEANUP CYCLE (Optional)
When a pump or blower is turned On by a button press, a cleanup cycle begins
30 minutes after the pump or blower is turned Off or times out. The pump and the
ozone generator will run for 30 minutes or more, depending on the system. You can
change this setting on some control systems. If cleanup is set to zero hours, this
feature will be disabled. (Cleanup is not included with all control systems, and control of
cleanup is not included with all control systems that have cleanup).
UNITS
Specify Time and Temperature Units . The temperature choices are Fahrenheit or
Celsius. The time display choices are 12 hour or 24 hour.