Hansa FCMW971291, Operating Instructions Manual

Page: 58 / 124

- 58 -
GAS CONNECTION
• WARNING: Before starting any work related with gas installation,
turn off gas supply. Risk of explosion.
• Please operate your oven in dry atmosphere.
• Fit the clamp to the hose. Push one of the hose until it goes to the
end of the pipe.
• For the sealing control; ensure that the buttons in the control panel
are closed, but the gas cylinder is open. Apply some soap bubbles to
the connection. If there is gas leakage, there will be foaming in the
soaped area.
• The oven should be using a well ventilation place and should be
install on flat ground.
• Re-inspect the gas connection.
• When placing your oven to its location, ensure that it is at the counter
level. Bring it to the counter level by adjusting the feet if necessary.
• Do not make gas hose and electrical cable of your oven go through
the heated areas, especially through the rear side of the oven. Do not
move gas connected oven. Since the forcing shall loosen the hose,
gas leakage may occur.
• Please use flexible hose for gas connection.
For LPG connection
For LPG (cylinder) connection, affix met-
al clamp on the hose coming from LPG
cylinder. Affix an edge of the hose on
hose inlet connector behind the appli-
ance by pushing to end through heat-
ing the hose in boiled water. Afterward,
bring the clamp towards end section of
the hose and tighten it with screwdriv-
er. The gasket and hose inlet connector
required for connection is as the picture
shown below.
NOTE: The regulator to be affixed on LPG
cylinder should have 300 mmSS feature.
Main Gas Pipe
Gasket
Hose Inlet Connector
Metal Clamp
Lpg Connection Hose
For natural gas connection
WARNING: Natural gas connection should
be done by authorized service.
For natural gas connection, place gasket
in the nut at the edge of natural gas con-
nection hose. To install the hose on main
gas pipe, turn the nut. Complete the con-
nection by making gas leakage control.
Main Gas Pipe
Gasket
Nut
Natural Gas
Connection Hose