Hansa C13 O&M Manual - OM-007 Revision L 28/06/2021
© Hansa Chippers 2020
10
The governor controls the maximum safe operating speed and protects the engine and all moving parts from
damage caused by overspeed
Operate the chipper with blunt knives
This causes excessive vibration which may result in damage to the chipper
Move or tilt the machine while it is running
Touch any guards or stick hands between guards while the chipper is running
Put hands or any other part of the body or clothing:
Inside the feed chute past the rubber flap
Inside or near the opening of the discharge chute
Near any moving part
Remove any guards on the chipper unless the engine is turned off and the cutting rotor has come to a complete standstill
Leave the chipper on while it is unattended
Starting procedure
Before proceeding, ensure the ‘safe setup procedure’ has been followed on page 5 of this manual.
Turn the choke lever, fuel lever,
and engine switch to the
“on”
position.
Turn the throttle to max position
and disengage the belt drive by
winding the engagement handle
anti clock-wise until it comes to a
stop.
Pull the pull cord in one smooth
motion to start the engine.
Once the engine is started and has
warmed up (approx. 10 seconds),
turn the choke lever to the “off”
position (as shown in the picture).
1
1
2
3
4
Pull cord
Throttle
lever
(“max”
position)
Choke lever
(“on” position)
Fuel lever
(“on” position)
