Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The shower system may only be used for bathing, hygienic
and body cleansing purposes.
The hot and cold supplies must be of equal pressures.
Assembly
(see page 33)
Important! The fitting must be installed, flushed and tested
after the valid norms.
Flush through the supply pipes.
Place the mixer including the sealing washer in
position on the basin / bidet.
Slide the fixation piece including the washer over
the threaded pins and tighten the nuts.
Connect the supply pipes to the isolation valves;
cold right - hot left.
Connect the pull rod to the pop-up waste.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
1.
2.
3.
4.
5.
Technical Data
This mixer series-produced with EcoControl®
(flow limiter).
Rate of flow with EcoControl:
7 l/min 0,3MPa
Rate of flow without EcoControl:
12 l/min 0,3 MPa
Operating pressure:
max. 1 MPa
Recommended operating pressure:
0,1 – 0,5 MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 80° C
Recommended hot water temp.:
65° C
Hansgrohe mixers can be used together with hydraulically
and thermically controlled continuous flow heaters if the
flow pressure is at least 0,15 MPa.
If the continuous water heater causes any problems or
there is not enough flow of water, the EcoControl® located
behind the aerator must be removed.
To adjust the hot water limiter on single lever mixers, please
see page 37.
No adjustment is necessary when using a continuous flow
water heater.
Spare parts
(see page 3)
Special accessories
special tool set (58085000) order as an extra
Cleaning
(see page 38)
English
Summary of Contents for Zenio Metro 31651000
