Hans Grohe Talis E2 31666000, Manual

Page: 12 / 40

1
English
Important! The fitting must be installed, flushed and
tested after the valid norms.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure: 1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature: max. 80° C
Recommended hot water temp.: 65° C
Rate of flow by 0,3 MPa: ca. 32 l/min
Hansgrohe single lever mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
To adjust the hot water limiter on single lever mixers,
please see page 8.
No adjustment is necessary when using a continuous flow
water heater.
Spare parts (see page 4)
handle Talis E² 31692000
screw cover 96338000
handle Metropol S 14895XXX
handle Focus S 31793000
handle Talis S / Talis S² 32096000
handle Metris S 31093000
handle Talis Classic 14193XXX
handle Focus E² 98532000
handle PuraVida 95273XXX
handle Metris Classic 31294XXX
face plate 98792XXX
face plate PuraVida 95276XXX
face plate Metris Classic 95412XXX
flange 98790XXX
fixing screw 96454000
sub plate 98793000
nut 98796000
cartridge cpl. 92730000
locking screw for handle 95140000
seal 95008000
screw M5 x 20 (4) 96525000
noise reduction 94073000
extension 25 mm 13595000
extension 22 mm 13597XXX
extension 22 mm 15597000
XXX = Colors
000 chrome plated
400 white/chrome plated
820 brushed nickel
880 satin chrome
1�
2�
3�
4�
5�
6�
7�
8�
9�
10�
11�
12�
13�
14�
15�
16�
17�
18�
19�
20�
21�
22�
23�
24�
25�
Fault
Cause Remedy
Mixer stiff
- Cartridge defective, calcified - Exchange cartridge
Mixer dripping
- Cartridge defective, sedimentation - Exchange cartridge
Hot water temperature too low, no
cold water.
Instantaneous water heater starts up
when cold water is selected.
- Hot water limiter incorrectly set
- Crossflow
- Set hot water limiter
- Exchange seal (20)
Exchange O-ring