4
Trim installation
Turn the water off at the main before beginning.
Remove the cover (1), bonnet nut (2), and test cap (3),
from the valve body. If the screen (5) is still present,
remove it as well.
If the valve is installed in a fiberglass or acrylic enclo-
sure, the plaster shield (4) must remain in place. In all
other installations, the plaster shield may be removed, if
desired.
Normal installation:
Insert the cartridge in the
valve with the “hot side” marking on the left.
Reversed installation
(cold on left/hot on right)
:
Insert the cartridge so that the “hot side” markings are
on the right.
All installations:
Make sure that the cartridge en-
gages the holes inside the valve. The keys on the sides
of the cartridge should engage the slots on the sides of
the valve.
Install the bonnet nut. Tighten it hand tight.