3
Installation considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, profes-
sional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• Pressure balance valve rough 04120000 (not
included) must be installed, and the finished
wall surface must be installed and made wa-
tertight before installation of this trim kit.
• The tub spout (included with 04210000 /
04199000 / 04203000 only) requires a ½"
NPT male nipple, extending 4" - 4 ¼" outside
the surface of the finished wall.
• The shower arm requires a ½" NPT female
fitting.
• The max. flow rate of the valve is 4.5 GPM.
IP C showerhead
1.6 GPM max
Full spray, massage, intense
massage
IP E,S showerhead
1.6 GPM max
Full spray, massage, intense
massage
• The max. flow rate of the showerhead is 1.6
GPM.
• The shower valve incorporates a high tem-
perature limit stop which must be set to comply
with local plumbing codes.
• This product is for use with shower heads rated
at 1.5 GPM (5.6 l/min) or higher.
• To prevent scald injury, the maximum output
temperature of the shower mixing valve (not
included) must be no higher than 120°F. In
Massachusetts, the maximum output tempera-
ture can be no higher than 112° F.
• Know and follow all applicable local plumb-
ing codes when setting the temperature on the
water heater.
½"
3"
5¼"
26°
26°
3¼"
G ½
3"
4"
26°
26°