6
7
English
Attention!
The fitting must be installed, flushed and
tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the sink.
3. Slip the plastic washer, the slide washer, the
metall washer and collar nut over the hose
and threaded base and tighten the collar nut
by hand. If there is not enough space, please
use only the slide washer and the metall without
the plastic washer.
4. Tighten screws.
5. Connect the connecting hose to the angle valves;
cold right - hot left.
Large differences in pressure between the hot and
cold water supply should be balanced.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
Technical Data
Operating pressure:
max. 1 MPa
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
1,6 MPa
Hot water temperature:
max. 80° C
Recommended hot water temp.: 65° C
Rate of flow:
11 l/min 0,3 MPa
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPa.
To adjust the hot water limiter on single lever mixers,
please see page 17.
No adjustment is necessary when using a continuous
flow water heater.
Spare parts
(see page 3 + 4)
1 lever head
33891000
1.1 screw cover
96338000
2 flange
96391000
3 nut
94194000
4 cartridge cpl.
92730000
5 aerator cpl.
13913000
6 fixation cpl.
95049000
7 connection hose 600 mm 3/8" 96510000
8 connection hose 600 mm
14099000
9 ELASTOP stop unit
94849000
10 seal
95008000
11 sealing set
96529000