Hans Grohe AXOR Starck 10754180, Assembly Instructions Manual

Page: 4 / 212

4
X
1.
L
N
PE
FI
1
0
1
0
%
Technical Data
Operating pressure: max. 1,0 MPa
Recommended operating pressure: 0,15 - 0,6 MPa
Test pressure: 1,6 MPa
Hot water temperature: max. 80° C
Recommended hot water temp.: 65° C
Connections G 3/4
Rate of flow by 0,3 MPa:
10750180 1 Consumer
44 l/min
10750180 2 Consumer 55 l/min
10650180 25 l/min
10971180 55 l/min
28486180 50 l/min
non return valve
The non return valves must be checked regularly
according to DIN EN 1717 in accordance with
national or regional regulations (at least once a
year).
Sequence power
The performance of the waste must be of sufficient
size.
Flush piping system
To complete the installation flush out both hot and
cold water supply.
Fastening material
Only suitable fastening material may be used!
The enclosed screws and plugs are only suitable
for concrete.
Arrangement of the modules
Adjust the module arrangement to the local
conditions
(Installation examples see pages 32...49.)
Residual current protection system
The system must be protected via a leakage
current protective device (RCD/ FI) with a measu-
rement difference current of ≤ 30 mA.
Electrical connection
Preinstall electrcal power 230 V/N/PE/50 Hz
(length: 0.3 m)
The current version of the applicable regulations
from VDE, local authorities and utility companies
must be observed for electric installation work.
Test certificate
Area for required wall rein-
forcement
The wall must be reinforced in this
area.
Middle of shower stall
Amplifier for speaker
connectors
Illuminant
transformer
light switch
FI protective switch
conductor
neutral conductor
Potential equalisation
Empty pipe EN20
Electricity on / off
Pipe decline
Install water pipes for body showers
with a gradient.
Plug outlets
Plug the unused outlet.
Silicone (free from acetic
acid!)
Installation sequence
Water on / off
Electrician
The installation and testing work must
be performed by a skilled electrician
in observance of VDE 0100 part 701
and IEC 60364-7-701.
Water connection
Cold water
Water connection
Warm water
Note
Points out information to the affected
personnel, whose content is important
and must be taken into consideration.
Technical Data
Dimensions
Installation tool/ Installation
sequence
EN