Hans Grohe AXOR Montreux 16530 Series, Assembly Instructions Manual

Page: 17 / 173

5
Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1
Flush through the supply pipes.
2 Place the mixer including the sealing
washer in position on the basin.
3 Push connection piece over the tails and
tighten with nut.
4 Connect the supply pipes to the isolation
valves; cold right - hot left.
Technical Data
This mixer series-produced with EcoSmart®
(flow limiter).
Rate of flow with EcoSmart:
5 l/min 0,3 MPa
Rate of flow without EcoSmart:
9 l/min 0,3 MPa
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 – 0,5
MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 80° C
Recommended hot water temp.: 65° C
Hansgrohe mixers can be used together with
hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPa.
If the continuous water heater causes any
problems or there is not enough flow of water,
the EcoSmart® (5a) located behind the aerator
must be removed.
Spare parts see page 3 + 4
1 handle
Terrano 37298XXX
2 handle Uno 96318XXX
3 aerator cpl. 96336XXX
4 aerator cpl. 96673XXX
5 shut off unit 94149000
6 fixing set 96016000
7 connection hose 13099XXX
8 supply pipe 96786000
9 handle Monteux 16597XXX
10 sleeve 97993XXX
11 shut off unit 94009000
12 aerator cpl. 98583XXX
13 fixing set 96078000
XXX
= Colors
000 chrome plated
810 satinox
820 brushed nickel
830 polished nickel
Test certificate
DVGW P-IX SVGW ACS NF WRAS KIWA
37130XXX
P-IX
9370/IA
38130XXX
P-IX
9377/IA
X
16530XXX
P-IX
18196/IA
X X
Hansgrohe · Postfach 1145 · D-77761 Schiltach · T49 (0) 78 36/51-1282 · T49 (0) 7836/511440
E-Mail: info@hansgrohe.com · Internet: www.hansgrohe.com
11/2
00
9
9.09
17
2.0
7
E
n
g
lish
English