Hans Grohe Axor Montreux 16502 Series, Assembly Instructions Manual

Page: 17 / 174

5
Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1
Flush through the supply pipes.
2 Place the mixer including the sealing
washer in position on the basin / bidet.
3 Slip the slide washer, washer and collar nut
over the threaded base and tighten the
collar nut by hand.
4 Connect the supply pipes to the isolation
valves; cold right - hot left.
5 Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal
pressures.
Technical Data
This mixer series-produced with
waterdimmer® (flow limiter).
Rate of flow with waterdimmer:
7 l/min 0,3 MPa
Rate of flow without waterdimmer:
11 l/min 0,3 MPa
Operating pressure: max 1 MPa
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max 80° C
Recommended hot water temp.: 65° C
The aerator is not equal to DIN EN 246
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15 MPa.
If the continuous water heater causes any
problems or there is not enough flow of water,
the waterdimmer® (4a/11a) located behind the
aerator must be removed.
Spare parts see page 4
1 handle
16291XXX
2 screw cover cold/ hot 97987000
3 spout large model 97990XXX
4 aerator cpl. 97991XXX
5 shut off unit 94009000
6 pull rod 98730XXX
7 fixing set 13961000
8 connection hose 96321000
9 spout small model 97992XXX
10 spout for bidet 97364XXX
11 aerator cpl. 97360XXX
12 sleeve 97993XXX
13 supply pipe 96638000
Special accessories
X special tool set 58085000
(order as an extra)
XXX
= Colors
000 chrome plated
820 brushed nickel
830 polished nickel