Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer
in position on the basin.
3. Slip the slide washer, washer and collar nut
over the threaded base and tighten the collar
nut by hand.
4. Tighten screws.
5. Connect the supply pipes to the angle valves;
cold right - hot left.
6. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and cold
water supply should be balanced.
Operation
The mixer is actuated by turning the handles,
left = hot water, right = cold water.
Technical Data
This mixer series-produced with waterdimmer
(flow limiter)
Rate of flow with waterdimmer:
5 l/min 0,3 MPa
Rate of flow without waterdimmer:
13 l/min 0,3 MPa
Operating pressure:
max. 1,0 MPa
Recommended operating pressure:
0,1 - 0,5 MPa
Test pressure:
1,6 MPa
(1MPa = 10 bars = 147 PSI)
Hot water temperature:
max. 80° C
Recommended hot water temp.:
65° C
Test certificate:
WRAS
Hansgrohe mixers can be used together with hydraulically
and thermically controlled continuous flow heaters if the
flow pressure is at least 0,15 MPa.
If the continuous flow heater makes any problems or there
comes not enough water, the flow limiter (3a) located
behind the mousseur must be removed.
English
Spare parts
(see page 3)
1
knob for cold water
17291XXX
2
knob for hot water
17292XXX
3
mousseur cpl.
13085XXX
4
stop unit
94149000
5
pull rod cpl.
94028XXX
6
fixation cpl.
13961000
XXX
= Colors
000 chrome plated
090 chrome/gold plated
Summary of Contents for AXOR Carlton 17032 Series
Page 1: ...Montageanleitung Carlton 17032XXX ...
Page 3: ... 3 6 1 4 3a 2 5 ...
