Hans Grohe 33107000, Assembly Instructions Manual

Page: 16 / 174

4
Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1
Flush through the supply pipes.
2 Place the mixer including the sealing
washer in position on the basin / bidet.
3 Slide the fixation piece including the washer
over the threaded pins and tighten the nuts.
4 Connect the supply pipes to the isolation
valves; cold right - hot left.
5 Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal
pressures.
Technical Data
This mixer series-produced with
waterdimmer® (flow limiter).
Rate of flow with waterdimmer:
7 l/min 0,3 MPa
Rate of flow without waterdimmer:
17 l/min 0,3 MPa
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 – 0,5
MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
max. 80° C
Recommended hot water temp.: 65° C
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15 MPa.
If the continuous water heater causes any
problems or there is not enough flow of water,
the waterdimmer® (6a) located behind the
aerator must be removed.
To adjust the hot water limiter on single lever
mixers, please see page 5.
No adjustment is necessary when using a
continuous flow water heater.
Spare parts see page 3
1 handle
33092000
1.1 screw cover 96338000
2 flange 96468000
3 nut 96461000
4 cartridge cpl. 92730000
5 seal 95008000
6 aerator cpl. 94010000
7 fixing set 95049000
8 connection hose 450 mm 97372000
9 pull rod 96657000
10 locking screw for handle 96059000
11 spout cpl. 96521000
12 sealing set 92646000
Special accessories
X special tool set 58085000
(order as an extra)
English