• Persons with restricted movement should be assisted by a second person when working on their feet.
• Make sure the work area is well lit.
• Make sure that the device is not started accidentally. Make sure that the switch is in the OFF position "0"
before plugging in the power plug. If the device is already switched on when plugged in, it may cause an
accident.
• Wear a hair net if you have long hair. Hair may be caught in moving parts.
• Pull the power plug out of the mains socket before changing accessories or putting the device away. This
precaution will ensure that the device does not operate accidentally.
• Switch the device off immediately if it is defective or nor working properly.
• Only use the device with the accessory parts supplied.
• Do not leave the device operating unattended.
• Do not use the device under blankets, pillows etc.
• Do not operate the device for longer than 20 minutes in one session. Then stop it for at least 30 minutes
to prevent the motor overheating.
• Never use the device while you bathe or shower. Do not store or keep the device in places from which it
can fall into a bathtub or washbasin.
• Never immerse the device in water or other liquids. If the device falls into water, pull out the power plug
immediately. Hands must be dry when operating the device and plugging in the power plug.
• For reasons of hygiene, the device should only be used on one person.
• Clean the device after using it on the foot before using it on your hands or vice versa to prevent transmission
of skin diseases (such as tinea).
• Keep the device clean, dry and free from oil and grease.
• Keep the device away from heat sources.
• Take care at all times. Always be aware of what you are doing and work carefully at all times.
• During use on the skin the device may become hot.
• The device can become very hot during long, intensive use, e. g. when sanding off calluses on feet. To
prevent burns to the skin in these cases, longer breaks must be taken between individual uses. For your own
safety, continuously check the heat development of the device. This particularly applies to heat-sensitive
users.
• Check the results regularly when using the device. This is particularly important for diabetics, because they
may be less sensitive to pain and may injure themselves more easily. Take particular care when working
with the device. If in doubt, consult your doctor.
2. Description of parts
1 Device housing
2 Sapphire wheel
3 Handle with axle
4 Flexible spiral shaft
5 Catch
6 Display
7 Rotary switch
8 Sapphire milling cutter
9 Flame milling cutter
10 Cylindrical milling cutter
11 Sapphire callus sander
12 Sapphire cone
13 Felt cone
1
2
3
4
5
6
7
8
9
10
11
12
13
Summary of Contents for SANITAS SMA 70
Page 23: ...23 7 2 1...
Page 24: ...24 0 20 30...
Page 26: ...26 0 0 5 5 1 I II 0 5 2...
Page 27: ...27 162 563 7 6 90 7 2002 96 EC WEEE Waste Electrical and Electronic Equipment...
