Page 4
ASSEMBLY INSTRUCTIONS
1
2
Attach the leg support to the chair legs(B1 & B2) by using the 1/4"x20 mm bolts and washers as shown in
.
Guide these bolts through the holes in the leg support into pre-drilled holes in the chair legs.
.
Fig 1
Hand tighten only
.
,
Attach the support bar to the chair legs by using the 1/4"x20 mm bolts and washers as shown in
. Guide these
bolts through the holes in the support bar into the pre-drilled holes in the chair legs.
.
Fig 2
Hand tighten only
.
,
3
At this time make any adjustments to alignment of all parts. Tighten all bolts a few revolutions at a time, alternating
between bolts until tightened.
.
Do not over tighten. Over tightening may strip bolts
J
E K
D
B2
B1
E
K
FOOT CAP
C
Fig. 1
Fig. 2
J
4
5
Set the chair frame on the rocker assembly with front of the seat facing you and the arrows on the "U" bar pointing
towards you as shown in
. This is very important for a safe, balanced rocking motion.
.
Fig 3
If chair frame has been
properly positioned on the rocker assembly, all arrows on the "U" bar and rocker assembly will be pointing
in the same direction.
Critical Step: The "U" metal plates must be installed in the proper location.
Fig 4
Fig 5 Hand tighten only.
Adjust alignment of the holes of support bar and "U" bar Insert a "U" metal plate as shown in
. Then
guide the 5/16"x40 mm bolts through the holes in the "U" metal plate “U” bar, rocker plate and bottom of the “U”
metal plate. Add a Ø8.0 x 2.3 mm spring washer and a nut to each bolt as shown in
.
Repeat the same procedure on the other side.
Read this step and carefully
examine.
.
.
,
,
.
H
A
Fig. 3
FOOT CAP
Fig. 4
Fig. 5
ROCKER PLATE
"U" BAR
ROCKER
ASSEMBLY
"U" BAR
L
L
F
G
I
