11
LIGHTING INSTRUCTIONS
Warning: If these instructions are not followed exactly, a fire or explosion may result in
causing property damage, personal injury or loss of life.
1. Make sure the control knob is in the "OFF" position. See Figure 12 Open the tank
valve all the way.
2.Push in the igniter button. You will hear a slight clicking sound. With the igniter button
pushed in, push and turn the control knob to the “ON” position. The fire should light
within a few seconds. Once the flame is lit, release the igniter button and continue to hold
the control knob in for 10 to 15 seconds. Release the control knob. The control knob
should pop back out and then remain lit.
Note: If the fire does not light, turn the knob to the “OFF” position and wait five (5)
minutes before trying again.
3. To turn down the flame, push the control knob in slightly and turn to Medium (medium
or Low (small flame).
4. To shut down the fire pit, turn the control knob to the “OFF” position and turn off the
tank valve.
MAINTENANCE
The flames should look like those in Figure 13 To clean
the burner, use a soft brush after the burner has cooled
completely. Never use a vacuum cleaner on the burner.
It is recommended that the fire pit is stored indoors
during the winter if it will be subjected to freezing
temperatures. The LP cylinder must be disconnected
and removed from the appliance before the appliance
can be stored indoors.
Figure 13
IGNITER BUTTON
CONTROL KNOB
Figure 12
