FOOT CAP
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
Step 1:
Remove all protective materials and set parts on a flat,
non-abrasive surface. Identify parts packed in carton
against the parts list. If you are missing any parts or are
unsure how to proceed with assembly, call our Customer
Service Center at 1-800-416-3511.
Do not attempt
assembly if any parts are missing or damaged.
1/4"x30 mm
Step 2:
Attach bottom base to the middle base by using four
bolts and washers as shown in
Fig.1
.
Guide the bolt through the holes in bottom base and
into the pre-drilled holes in the middle base.
Do not
over
tighten.
With the help of another person
,
turn
the table base assembly in the upright position.
D
Fig.1
Fig.2
E
G
C
Step :
With the help of another person, carefully please
the table top onto top base
1/4"x45 mm
4
,
using four
bolts and washers as shown in
Fig.3
.
Guide bolts
through the holes in top base and into the pre-drilled
holes in the table top.
Do not over
tighten .
Fig.3
Step
5
:
After making any necessary adjustments to the alignment of
the table top and top base, use the hex bolt driver to tighten
all bolts.
Note:
each bolt must be tightened a few
revolutions at a time. In order to apply equal pressure to
all bolt joints, we recommend working in a cross corner
(X fashion). Repeat until all bolts are tight.
Do not over
tighten
. Over tightening may strip bolts.
Your table is now ready for use. If you have any questions,
please call our Customer Service Center at 1-800-416-3511.
Step 6:
IMPORTANT NOTE: Damage to welds or frames resulting
from over tightened bolts or improper assembly is not covered
under our warranty. Please read all instructions carefully before
assembly. If you have any questions regarding your assembly,
call our Customer Service Center at 1-800-416-3511.
E
G
B
A
G
F
Step 3:
1/4"x30 mm
Attach top base to the middle base by using four
bolts and washers as shown in
Fig.2
.
Guide the bolt through the holes in top base and
into the pre-drilled holes in the middle base.
Do
not over
tighten .
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
DLQ01317
PARTS LIST
DESCRIPTION
ORDER PART #
HEX BOLT DRIVER
1/4" X 30MM BOLT
TABLE TOP
QTY
1
12
8
1
1
SE00F4653
HW0712
HW0038
A
B
C
D
E
F
G
H
I
J
K
Ø
6.5 X 1.5 MM
WASHER
1/4" X 20 MM BOLT
4
HW0036
BOTTOM BASE
MIDDLEOM BASE
TOP BASE
1
1
FOOT CAP
FC0404
G0157
4
PLASTIC UMBRELLA
HOLE RING
FACTORY ASSEMBLY
UMBRELLA POLE
STOPPER
(
SET
)
1
1
G0226
