7
6. Remove backing from the Noise Attenuation Pads (P13) and
position along the brackets as shown.
7. Slide the two Crossbar Center Rails (P5) into the two Crossbar Ends (P4) ensuring:
a. The slots in the Center Rails (P5) face inward.
b. The slots in the Center Rails (P5) are closer to the top edge when the base is upside down (see
inset).
8. For the two Crossbars that will be the outer legs of the desk
base, attach a Foot (P2) with four M6*14 Machine Screws (P14)
and tighten the screws in a cross pattern
.
Attaching The Desktop
Note:
Your desktop is pre-drilled. Check both sides of the desktop before placing the desk base on the
underside of the desktop.
1. Place the desktop face down on a clean surface.
2. Carefully place the upside down desk base on the underside of
the desktop. Adjust the width of the 2-leg desk base to fit the
pre-drilled desktop by sliding the two halves outward.
3. Double check that the desk base is properly aligned with the pre-
drilled holes on the underside of the desktop.
