6
Assembly Instructions
Assembling the Base
NOTE:
Lay out all components and hardware on a clean surface to ensure you have all components and
hardware listed on the parts page.
1. Fully separate the Crossbar Ends (P4). You
will find the Crossbar Center Rails (P5) inside.
2. Position one of the Crossbar Ends (P4) on its side.
Place one of the Legs (P1) into the Crossbar End (P4) ensuring the
bar (arrow) is on top in relation to the Leg (P1). Line up the holes
on each Leg (P1) with the holes on each Crossbar End (P4).
3. Using the supplied Allen Wrench, insert four M6*14
Machine Screws (P14) through the holes in each Crossbar
End (P4) going into the Leg (P1) and rotate each screw just
a few turns. You will need to flip the Crossbar over to gain
access to all four screws. Repeat Step 3 with the other
Crossbar
.
WARNING:
DO NOT tighten the screws at this point.
NOTE:
If you drop a screw inside the Crossbar End (P4), simply tilt to
retrieve.
4. Prop up one of the Crossbars from Step 3, as shown. Insert four
M6*14 Machine Screws (P14) through the four holes of the side
bracket (P6 or P7) going into the Crossbar End/Leg assembly.
Using the Allen Wrench, rotate each screw just a few turns.
Repeat Step 4 with the other two Crossbars.
WARNING:
If you are having difficulty inserting any of the screws from
Step 3 or 4, it is because some of the screws are too tight.
5. Tighten all the screws from Step 3 and Step 4
.
