52
PC INTERFACE
PC INTERFACE
PC INTERFACE
PC INTERFACE
PC INTERFACE
(((((not for
not for
not for
not for
not for HI 98180, HI 98181)
HI 98180, HI 98181)
HI 98180, HI 98181)
HI 98180, HI 98181)
HI 98180, HI 98181)
Data transmission from the instrument to the PC can be done with the
HI 92000
Windows
®
compatible software (optional).
HI 92000
also offers graphing and
on-line help feature.
Data can be exported to the most popular spreadsheet programs for further analysis.
To connect your instrument to a PC, use an
USB
cable connector. Make sure
that your instrument is switched off and plug one connector to the instrument
USB
socket and the other to the serial or USB port of your PC.
Note:
• If you are not using Hanna Instruments
HI 92000
software,
please see the following instructions.
SENDING COMMANDS FROM PC
It is also possible to remotely control the instrument with any terminal program.
Use an
USB
cable to connect the instrument to a PC, start the terminal program
and set the communication options as follows: 8, N, 1, no flow control.
COMMAND TYPES
To send a command to the instrument follow the next scheme:
<command prefix> <command
> <CR>
where:
<command prefix> is the 16 ASCII character
<command> is the command code.
Note:
Either small or capital letters can be used.
SIMPLE COMMANDS
KF1
Is equivalent to pressing
functional key 1
KF2
Is equivalent to pressing
functional key 2
KF3
Is equivalent to pressing
functional key 3
RNG
Is equivalent to pressing
RANGE
key
MOD
Is equivalent to pressing
MODE
key
CAL
Is equivalent to pressing
CAL
key
UPC
Is equivalent to pressing the
UP
arrow key
DWC
Is equivalent to pressing the
DOWN
arrow key
RCL
Is equivalent to pressing
RCL
key
SET
Is equivalent to pressing
SETUP
key
CLR
Is equivalent to pressing
CLR
key
