17
INST
ALLA
TION
6. INSTALLATION
General Guidelines
• Select controller location so that it is shielded from direct sunlight, dripping water and excess
vibrations.
• Keep flow rate as constant as possible for optimum sensor operation.
• Install cable gland fittings and plugs as needed, to properly seal the pump controller.
• The probes are easily installed using 1/2" NPT threads for in-line or flow cell installation.
• For optimal operation, all tubing, cables, saddles and fittings must be properly connected.
Note:
BL100
and
BL101
pump controllers are shipped with two types of tubing, for both flow
cell and in-line configurations:
-
rigid tubing for outlet (dispensing) - connects the pump output to the injector
-
flexible tubing for inlet (aspiration) - connects the filter to the pump inlet
Installation Steps
1. Check the tank level.
2. Calibrate the probe before use in the system.
3. Mount the probe into saddle or into a flow cell.
4. Connect the aspiration tubing between the chemical tank and the pump's inlet.
5. Connect the dispensing tubing between the pump and injector.
6. Check the level sensor's functionality (if used).
