Unicorn 3002 User Manual
6.1.8.
Rebooting the Unicorn 3002
You can reboot the Unicorn 3002 by clicking on the “Reboot” button after each update to
the configuration page. Alternatively, you can reboot by unplugging the power supply of
the Unicorn 3002 and then powering it on again. If your Unicorn 3002 ever becomes
“stuck” or un-responsive, you can unplug the power supply to reboot it. Frequent
rebooting by unplugging the power supply is not recommended and should not be
necessary.
6.2.
Configuring Unicorn 3002 via Voice Prompt
6.2.1.
DHCP Mode
Follow section 5.1 with voice menu option 01 to enable Unicorn 3002 to use DHCP
6.2.2.
STATIC IP Mode
Follow section 5.1 with voice menu option 01 to enable Unicorn 3002 to use STATIC IP
mode, then use option 02, 03, 04 to set up Unicorn 3002’s IP, Subnet Mask, Gateway
respectively.
6.2.3.
Configuration through a Central Server
Unicorn 3002 devices can be automatically configured from a central provisioning system.
When Unicorn 3002 boots up, it will send TFTP or HTTP request to download
configuration files. There are two configuration files, one is “cfg.txt” and the other
is“cfg001fc1xxxxxx”, where “001fc1xxxxxx” is the MAC address of the Unicorn 3002.
For more information regarding configuration file format, please refer to the
related
technical documentation.
The configuration file can be downloaded via TFTP or HTTP from the central server. A
service provider or an enterprise with large deployment of Unicorn 3002s can easily
manage the configuration and service provisioning of individual devices remotely and
automatically from a central server. The central provisioning system uses enhanced (NAT
friendly) TFTP or HTTP (thus no NAT issues) and other communication protocols to
communicate with each individual Unicorn 3002 for firmware upgrade, etc.
http://arttel.ru
http://arttel.ru/shop/voip-shlyuzy/golosovoj-shlyuz-hanlong-unicorn-3002
