Hanlon 56836, Instruction Manual, Page: 9 / 16

9
CROSSBEAM AND SHELF STRAP INSTRUCTIONS
Note: It is recommended for one person to hold the upright
frames in place while a second person installs the crossbeams.
STEP 1
• There is a set of locking tabs at both ends of every crossbeam.
To begin assembly, take one crossbeam and insert the tabs into
two of the holes on the lower portion of one upright frame.
Engage the locking tabs into the holes using a downward
motion. The locking pin hole should be at the top. Make sure the
end of the crossbeam is flush against the upright frame.
STEP 2
• Repeat for the opposite side of the crossbeam. Tap the ends
of the crossbeam (closest to the upright frames) with a rubber
mallet until fully seated. The crossbeam and locking tabs should
easily slip into place. If they do not, then recheck the alignment
of the teardrop -shaped holes and tabs. Too much force may
damage the interlock between the crossbeam and upright frame.
STEP 3
• Using the methods listed above, install another crossbeam to
the opposite side of the upright frames, parallel to the first
crossbeam you installed. Make sure both crossbeams are at the
same level.
ASSEMBL
Y
NOTE:
It is recommended for one person to hold the upright frames in place
while a second person installs the crossbeams.