Hanlon 56836, Instruction Manual, Page: 13 / 16

13
STACKING INSTRUCTIONS
Note:
Every Kitchen Rack comes with two (2) stacking brackets. In
order to safely stack two of these racks together, you MUST use four
(4) brackets.
It is recommended that one person holds the upright frames in place while
a second person installs the stacking brackets.
STEP 1
• Assemble the second set of upright frames by following the
instructions on Page 8.
STEP 2
• Using a screwdriver and rubber mallet, remove all four black caps
from the bottom of the newly assembled upright frames. This will
now become the top rack. Remove all four black caps from the top
of the fully assembled rack. This will now become the bottom rack.
ASSEMBL
Y
STEP 3
• Line up and place an upright frame on top of one side of the fully
assembled rack. Be sure the hole patterns are going in the same
direction. The stacking brackets feature a top and bottom set
of locking tabs. Engage the top set of tabs into the very bottom
of the vertical beam and the bottom set of locking tabs into the
very top of the upright frame. Use the same downward motion to
attach these brackets as you did for the crossbeams. The locking
pin holes on the bracket should be at the bottom. Repeat for the
remaining three stacking brackets.
STEP 4
• Insert the locking shelf pins into the open holes on the brackets.
Assemble the remaining pieces of the top rack by following the
steps detailed on Pages 8-12.
TOP RACK
BOTTOM RACK
UPRIGHT
FRAME
VERTICAL
BEAM
WARNING!
Serious or fatal crashing injuries can occur from furniture tipping
over. To prevent this, the rack must be secured to a wall, especially in
earthquake-prone environments, where surfaces are uneven, and where
children and/or pets are present
.
FPO