User's Manual of Fiber Laser Chiller
7
Must be
implemented
port and 2.0 meters around the outlet. If suction and exhaust
are obstructed, the cooling capacity of the equipment cannot
be used.
Before trial operation
Must be
implemented
a) Need to ensure that the equipment side water supply pipe
is not obstructed;
b)Need to check the water pipe and pump, confirm that there
is a proper amount of water into the pump, and the exhaust is
through the pump exhaust valve, otherwise it will cause
damage to the pump;
c) Confirm the condition of the equipment is normal and
safe, otherwise there may be injury and breakage.
Equipment no stampede
Prohibited
Please don't step on the equipment or sit on it, otherwise it
will cause the injury accident of falling.
Regular cleaning of air filters
Must be
implemented
Clean the air filter at least once a week. If the air filter is
obstructed, the refrigeration capacity will be reduced, the
power consumption will increase, and even the alarm will not
work properly.
Keep surface clean
Must be
implemented
a) Use non-corrosive cleaning agents for metals and plastics;
b) After cleaning, please take good care of the cleaning agent
to prevent liquid leakage anywhere in the equipment;
c) Containers that store detergents should be completely
sealed to avoid danger.
Wear protective gloves for
maintenance, repair and cleaning
Must be
implemented
a) The sharp edge of the condenser fin is dangerous to cut the
skin;
b) Internal compressor and refrigerant pipe temperature is
very high, direct contact with the skin has the risk of
scalding.
Anti-freezing
Must be
implemented
If the ambient temperature is lower than 0℃ and the
shutdown is long, the liquid should be discharged. Moreover,
use compressed air to clean the water in the system,
otherwise there is a risk of frostbite components and pipes.