Technical Support : +82-3452-8966 / [email protected]
17/22
4. Operation
After reaching the set speed, the centrifugation is decelated and stopped
1.
Set the desired speed.
▶ Refer to [
4
.
2
Setting Speed]
2.
Press the Short button more than 2sec.
[Saving]
1. Set the RPM(or RCF) / Run time / Accel, Decel rate
2. Press the Left of Right button until Prog display flashes(0).
▶ You can save 10(0~9) programs.
3. Press Up or Down button until the desired program number is displayed.
4. Press the Enter button.
[Calling up]
1. Press the Setup/Enter button.
2. Press the Left of Right button until Prog display flashes(0).
3. Press Up or Down button until the desired program number is displayed.
4. Press the Enter button.
4.8 Short Run
4.9 Saving/Calling up a Program
