Page
2
of
5
©HangmanSystems, LLC. Rev.1.17.
Once you have decided in which direction the HOOK
should open, install the HOOK on the HANGER by
sliding one end of the HANGER through the HOOK
eyelet, as shown in the photo.
Note that in this photo, the HOOK opens to the left, so
access to the Original Hangman™ Triple Secure™
storage system will be from the left side as it hangs in the
closet.
Unlock and open the DOOR, and insert one end of the
HANGER into one of the holes in the UNIT (holes on the
sides near the top). You can leave the other HANGER
end out for now. Place one of the WASHERS on the
HANGER end that is inside of the UNIT, then insert the
straight leg of the COTTER PIN through the hole in the
HANGER end. Pliers may make installation of the
COTTER PIN easier.
This photo shows the WASHER and COTTER PIN in the
correct position.
If you haven’t installed the HOOK on the HANGER, you
need to do so now!
Pull the HANGER in the direction of the remaining side
hole and insert the other HANGER end through this hole.
Repeat the steps above to install the WASHER and
COTTER PIN on this HANGER end.
Assembly is now complete!
INSTALLATION
Once you have assembled the Original Hangman™ Triple Secure™ storage system as described
above, you are ready to install the storage system in your closet. Just hang the storage system
from the closet rod (or metal closet system) so that the CABLE LOCK is on the backside (wall
side) of the closet, as shown below. We recommend placing items in the Original Hangman™
Triple Secure™ storage system once the storage system has been hung and the cable lock
installed.
Take the free end of the CABLE LOCK and feed it through the hole in the top surface of the
UNIT. Use the WING NUT to secure the CABLE LOCK to the UNIT. See picture below.
