25
Hangar 9 Taylorcraft 20cc Assembly Manual
Ignition and Engine Installation
Parts Required
Fuselage
Engine (G20EI)
Ignition Unit
#8 washer (4)
Medium cable tie (2) 1/4-inch foam rubber
3mm x 10mm socket head cap screw
8-32 x 1 1/2-inch socket head cap screws (4)
28mm aluminum standoffs (4)
Tools Required
1/8-inch hex wrench 3mm hex wrench
Threadlock
Sidecutters
Step 1
Form a 180-degree curve in a medium cable tie.
Step 2
Insert the cable tie into the lower ignition mount hole
and guide it out the upper hole.
Step 3
Cut a piece of 1/4-inch foam rubber the size of the
ignition unit. Place the ignition unit and foam against
the firewall and use a second cable connected to the
first tie to secure it.
Step 5
Use a 3mm hex wrench to remove the carburetor
isolator block from the engine.
Step 6
Apply a drop of threadlock to the end of each 8-32 x
1 1/2-inch socket head cap screws. Use a 1/8-inch
hex wrench to mount the engine with the bolts, #8
washers and 28mm aluminum standoffs.
