38
Hangar 9 P-51D Mustang Sport 40 Assembly Manual
noTE: SPECIAL ConSIDERATIon
WHEn uSIng A MInI SERvo
Step A
Before installing the servo you will need to use medium CA
to glue the servo adapter to the tray as shown. Allow the
epoxy to fully cure before proceeding.
Step B
Place the servo in the tray as shown. Use a pencil to tansfer the
locations for the servo mounting screws on the tray.
Step C
Use a drill and 1/16-inch (1.5mm) drill bit to drill the four
holes for the servo mounting screws.
Step D
Place 2–3 drops of thin CA in each of the holes to harden the
surrounding wood.
Step E
Secure the servo in the tray using the screws provided with
the servo and a #1 Phillips screwdriver.
Step 10
Use a pin vise and 5/64-inch (2mm) drill bit to enlarge a hole
in the servo horn that is 3/8-inch (10mm) from the center of
the servo horn.
