16
Section 5: Installing the Ailerons
Required Parts
• Wing
• CA hinges (6)
• Aileron (left and right)
Required Tools and Adhesives
• Thin CA
• T-Pins
Step 1
Locate three CA hinges. Place a T-pin in the center of
each hinge.
Step 2
Place the hinges in the precut slots in the aileron.
The T-pin will rest against the leading edge of the
aileron when installed correctly.
Step 3
Slide the aileron and wing together. The gap between
the leading edge of the aileron and wing should
be a maximum of approximately 1/64". Check to
make sure the gap at both ends of the aileron
are equal and that the aileron can move without
rubbing on the wing.
Note:
Do not use CA accelerator during the
hinging process. The CA must be allowed to
soak into the hinge to provide the best bond.
Using accelerator will not provide enough
time for this process.
Step 4
Remove the T-Pins and move the aileron to provide
the best access to the hinge. Apply thin CA to each
hinge. Make sure the hinge is fully saturated with CA.
Use a paper towel and CA remover/debonder to clean
up any excess CA from the wing and/or aileron. Make
sure to apply CA to both sides of the hinges.
