32
Using a G-62
Step 1.
Remove the metal engine mount (if attached) from the
G-62. Attach the B+B Cup engine mount.
Step 2.
Using 5-minute epoxy, glue the 1" x 1" square plywood
plates to the back of the firewall centered over the four predrilled
mounting holes. Blind nuts will be mounted in these plates.
When the epoxy has cured drill through the front of the firewall
using a 5/16" drill bit through the plywood plates at the four
engine mounting hole locations.
Step 3.
Install the engine on the adaptor plate and then to the
firewall using 1/4-20 x 1
1
/
2
" socket head cap screws, split
washers, and blind nuts.
Step 4.
Mount the Zenoah
®
throttle linkage to the engine as
per the instructions included with the engine. Cut out the servo
hole in the bottom plate as shown and mount the servo. Using a
4-40 threaded rod, a solder link and a 4-40 ball link, make up
the throttle pushrod to the appropriate length. Securely solder
the solder link in place and attach the 4-40 ball link to the
pushrod and the servo arm.
Step 5.
Install the muffler. An optional muffler (BIS07163)
is recommended.
Step 6.
Using a Moto-tool with a cut-off wheel and a drum
sander, cut an air outlet in the bottom of the cowl as shown. The
approximate size should be 5" x 5". It may also be necessary to
cut out an area for the mufflers to exit, depending on the mufflers
and engine you use.
Section 12: Mounting the Engine and Cowl
CONTINUED
