11
Step 5.
Using an 8-32 tap, tap the holes that you just drilled in
the aileron.
Step 6.
Mix a small amount of 30-minute epoxy and lightly coat
the inside of the tapped holes and the 8-32 x 2" Rocket City
screws. From the top of the aileron, screw the 8-32 x 2" into the
tapped holes and securely tighten. Wipe away any excess epoxy
with rubbing alcohol and a paper towel. Screw the A-nuts in
place as shown. Allow the epoxy to fully cure.
Step 7.
Screw the molded swivel links onto the inboard 8-32
screw until the distance from the aileron surface to the bottom of
the link is 5 /8". The outboard swivel link will be installed later.
Step 8.
Install the control horns in the opposite aileron using
the same method.
CONTINUED
Section 3: Installing the Aileron Control Horns
