Install the Roller Hinges with Traction Handles (TR-1003) onto the Table Bed (EP-1140)
• For ease-of-assembly, rest the Table Bed against the side of the A-Frame (Figure 5).
• Open the Cam Locks on each side of the Table Bed (Figure 6).
• With the Pivot Pins facing outward, insert the Roller Hinges into the brackets on each side of the Table Bed.
The Roller Hinges must slide between the Cam Locks and the Brackets.
• Engage one of the holes in the Roller Hinge over the bracket pin. Make sure the Roller Hinges are in the same hole
setting on both sides. Figure 7 shows the Roller Hinges engaged correctly in Setting C.
• Push down on the Cam Locks (Figure 8) to secure the hinges.
NOTE: Refer to the Owner’s Manual for an explanation of the hole settings. If you are unsure, use Setting C to start.
Step 3
Figure 5
Figure 6
Figure 7
Figure 8
A B C
2
1
3
Bracket Pin
2
Cam Lock
3
Pivot Pin
1
