1
2
1
Attach the Upper Support Arms to the Table Bed (EP-1140)
• Place the Table Bed face down on the floor and push down on the Support Beam, so the two holes align evenly with
the holes at the base of the Upper Support Arms (Figure 3). You may have to exert extra pressure to ensure that the
Support Beam slides over the rubber spacers.
• Insert the two bolts (EP-1149-B) into the open holes.
• Fasten each bolt with a washer (EP-1149-D) and nut (EP-1149-A).
• Using the Allen Wrench (EP-1128-A) to steady the bolts, tighten the nut onto the bolt with the larger wrench (F5-1088)
(Figure 4). Repeat with the second bolt.
Step 2
Figure 3
Figure 4
2
Support Beam
Upper Support Arms
