5
Mount the Control Box
Hold the Control Box flush against the side of the cabinet. The Electronic Lock port on the side of the cabinet
must be aligned with the Electronic Lock Cables from the Control Box. Before mounting the Control Box,
gently feed the Electronic Lock Cables through the Electronic Lock Cable port on the right side of the Key
Cabinet. Fasten the Control Box to the wall.
Connect the Electronic Lock Cable to the Electronic Lock Connector inside the Key Cabinet. Snap the cable
into the retaining clips on the inside of the cabinet to prevent contact with the Key Panels during operation.
Don't forget about your UPS!!! (Uninterruptable Power Supply) Warranty will be voided if a UPS is not used.
Mount the Key Panels
Each Panel is labeled with a letter in the lower outside corner, and each hook has a number. The panels should
be placed in alphabetical order from front to back in the cabinet. Slip top panel mounting pin into hole on top
key panel mounting bracket. Raise the panel as far up as it will go and rotate the bottom mounting pin into the
corresponding hole at the bottom bracket. Lower the panel into place. Repeat for all panels.
