H&S HI-DUMP 9215, Operator'S Manual

Page: 19 / 32

PREPARING FOR OPERATION
• Properly lubricate the
HI-DUMP
before operating. Refer to the Lubrication Chapter of this manual for
locations.
• Inspect the tractor hitch & wagon for fatigue, cracks, loose hardware, etc. before connecting the tongue
of the wagon to the towing vehicle with a 2” diameter or larger hitch pin. Do not use an inadequate pin
which may bend or break under severe conditions.
• Attach the H&S SC60000 safety chain. Pro vide only enough slack for turning.
• Clean all hydraulic couplings and connect them to the trac tor or towing vehicle.
* Volume of oil required to operate
HI-DUMP
: 6.2 gallons
* Recommended pressure: 2250 PSI Min.
• Check wheel bolts upon delivery, and periodically thereafter. Wheel bolts should be tightened to 340
ft./lbs. of torque. This torque is needed for the axle to carry its’ rated capacity.
• Check the tires for proper air pressure. Refer to the manufacturers recommended PSI rating on the tire.
• Do not operate the wagon near overhead power lines or other obstructions. Electrocution and or
damage to the wagon may occur.
• Operate the box through the lift cycle several times powering it at the end each way to purge the
system of air and rephase the system.
• Be sure to check the oil level in your tractor and add oil after cycling if needed.
PREPARING THE
HI-DUMP
TRANSPORTING
When transporting on the highway or roads;
• An SMV mount bracket is located on the rear of the
HI-DUMP . Always use a slow moving vehicle
emblem when transporting. Keep the SMV emblem and all reflectors clean and visible to warn other
motorists.
• Always rotate the lights to the widest position and use the flashing highway lights when traveling on
a road or highway, except where such use is prohibited by law.
• Obey all state and local laws concerning the use of the
HI-DUMP
on public roads.
• KNOW YOUR WEIGHT - Do not pull a machine that does not have brakes at more than 1.5 times the
weight of the towing vehicle.
• KNOW YOUR WEIGHT - Do not pull a machine that has brakes at more than 4.5 times the weight of
the towing vehicle.
• Always use an H&S SC60000 safety chain. Provide only enough slack in the chain to permit turning. Do
not use the safety chain for towing without a pin. Inspect the chain for damage and replace if necessary.
• ASABE Standards state that while transporting, any equipment that does not have brakes, the
maximum speed should NOT exceed 32 km/h (20 MPH).
• Always check for overhead obstacles during transport.
Overall height is 117”
Overall width is 158”
Overall length is 304”
Gross weight of the
HI-DUMP
15,243 lbs.