![background image](http://html1.mh-extra.com/html/hands/boiler-gun-bg44/boiler-gun-bg44_operating-manual_3069453069.webp)
Methods and materials for
containment and cleaning up
Refer to attached safety data sheets and/or instructions for use. Eliminate all ignition sources (no
smoking, flares, sparks, or flames in immediate area). Keep combustibles (wood, paper, oil, etc.)
away from spilled material. Stop leak if you can do so without risk. Move the cylinder to a safe and
open area if the leak is irreparable. Use water spray to reduce vapors or divert vapor cloud drift.
Isolate area until gas has dispersed. Dike far ahead of spill for later disposal. Scoop up used
absorbent into drums or other appropriate container. Prevent entry into waterways, sewer,
basements or confined areas. Following product recovery, flush area with water. For waste
disposal, see section 13 of the SDS.
Environmental precautions
Avoid discharge into drains, water courses or onto the ground.
7. Handling and storage
Precautions for safe handling
Pressurized container: Do not pierce or burn, even after use. Do not use if spray button is missing
or defective. Do not spray on a naked flame or any other incandescent material. Do not smoke
while using or until sprayed surface is thoroughly dry. Do not cut, weld, solder, drill, grind, or
expose containers to heat, flame, sparks, or other sources of ignition. Do not re-use empty
containers. Avoid breathing gas. Avoid contact with eyes, skin, and clothing. Avoid prolonged
exposure. Use only in well-ventilated areas. Wear appropriate personal protective equipment.
Observe good industrial hygiene practices.
Conditions for safe storage,
including any incompatibilities
Level 1 Aerosol.
Store locked up. Pressurized container. Protect from sunlight and do not expose to temperatures
exceeding 50°C/122 °F. Do not puncture, incinerate or crush. Do not handle or store near an open
flame, heat or other sources of ignition. Store in original tightly closed container. Store in a
well-ventilated place. Keep out of the reach of children. Store away from incompatible materials
(see Section 10 of the SDS).
8. Exposure controls/personal protection
Occupational exposure limits
U.S. - OSHA
Value
Components
Form
Type
PEL
5 mg/m3
Oil mist
Distillates Petroleum,
Hydroteated Light (CAS
64742-47-8)
US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000)
Value
Components
Type
PEL
9000 mg/m3
Carbon Dioxide (CAS
124-38-9)
5000 ppm
ACGIH
Value
Components
Form
Type
TWA
5 mg/m3
Oil mist
Distillates Petroleum,
Hydroteated Light (CAS
64742-47-8)
US. ACGIH Threshold Limit Values
Value
Components
Type
STEL
30000 ppm
Carbon Dioxide (CAS
124-38-9)
TWA
5000 ppm
US. NIOSH: Pocket Guide to Chemical Hazards
Value
Components
Type
STEL
54000 mg/m3
Carbon Dioxide (CAS
124-38-9)
30000 ppm
TWA
9000 mg/m3
5000 ppm
Biological limit values
No biological exposure limits noted for the ingredient(s).
Appropriate engineering
controls
Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates
should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation,
or other engineering controls to maintain airborne levels below recommended exposure limits. If
exposure limits have not been established, maintain airborne levels to an acceptable level.
3 / 9
Material name: LPS® 1 (Aerosol)
802 Version #: 01 Issue date: 10-01-2014
SDS US
P/N 100190, Rev. 1
Page 57
Summary of Contents for BOILER GUN BG44
