H&S 6128, Operator'S Manual

Page: 33 / 46

-31-
There are numerous grease fittings on your merger. If these are lubricated properly and often enough,
it will prolong the life of the merger. Grease daily during normal use and before and after storage and
after power washing.
Use a good grade of high quality grease. Make sure grease comes out around
the shaft on the sleeve type bearings. On the sealed ball bearings, grease should be added slowly until
a slight bead forms at the seals indicating the correct amount of lubricant. Wipe off excess grease to
prevent accumulation of grit around the bearings.
LUBRICATION
GENERAL INFORMATION
IMPORTANT:
Catch and dispose of fluid per local waste disposal regulations whenever service is
performed on hydraulic components (valves, cylinders, hoses, etc.) or transmission.
For the center cam gearboxes, use SAE30W motor oil. The gearboxes hold 26 ounces of oil.
The tongue reservoir holds 32 gallons of ISO 46 hydraulic oil. The complete ststem hold 42 gallons
A. (2) Zerks - One on each wheel hub.
B. (3) Zerks - PTO - One on each u-joint and one on the slide tube.
C. (6) Zerks - One on each end of each pickup head.
D. (2) Zerks - One on each head pivot.
(20) Zerks - Suspension System - 10 on each side.
E. (4) Zerks - One on each side of the cam on each head
B
A
(4 Zerks)
Cross
Conveyor
Idler
Bearings,
1 zerk on
the front
side of each
roller.
Grease
ANNUALLY
when belts are
removed
C
E
E