OPERATION
12
1. Voltage Display: Set desired welding voltage before welding. Displays actual welding
voltage when machine is working.
2. Alarm Led: When the machine senses LINE over voltage or low voltage, output over
current or over heat condition, the alarm pilot lamp will be on.
3. Power Led: Power led is illuminated when LINE voltage is applied to the machine.
4. Wire Feed & Current Display: Set desired wire speed before welding. Actual welding
current displayed when machine is working.
5. Wire Speed & Current Knob: Set the wire speed for desired welding current.
6. Current LED
：
When illuminated, display is actual output welding current.
7. Wire Speed LED
：
When illuminated, display is the desired wire speed.
8. Trigger Function Select: 2T = ON/OFF 4T = ON/Latch & Latch/OFF
9.
Wave Control Knob: Controls arc characteristic or the rate at which the amperage
rises when a short circuit is produced.
10. Welding Voltage Knob: Set the welding volts
11. Earth Output Connector
：
This polarity must connect the work piece.
12.
MIG Gun Connector: Euro-connect for torch cable to machine.
§4.2 Welding Operation
§4.2.1
Output Voltage Setting (V)
Turn knob to desired WELDING
VOLTAGE ―V‖ based on wire size, type and material being
welded per 4.3 below.
§4.2.2
Wire Speed Setting
Turn knob to desired WIRE SPEED ―M/Min‖ based on wire size, type and material being
welded per 4.3 below.
